Owners: Andrew Laing (1849)
Two as yet unnamed coal pits are known to have worked the
Carhurlie Coals in the vicinity of Carhurlie (now Carhurley)
and Balcormo Mains.
One pit lay on the east side of the road leading to
Houndshead Bridge, north of Carhurlie. The other lay in the
fields to the east of Carhurlie, almost equidistant between
the farms of Carhurlie and Balcormo Mains.
They probably worked the coals in the early part of the 19th
century but no details have yet come to light of shaft
depths, etc.
Click on Map to Zoom In
--------------------------------------------
Extract: Statistical Account
of Fife Parish of Largo - 1791
" ... coal may be wrought to advantage. On
the estate of Lundin, the coal has been cropped; but by erecting an
engine near the sea, a deep seam, which stretches over upon the
estate of Largo, would be opened. This would amply supply the
neighbourhood, and afford besides a considerable exportation.
..."
--------------------------------------------
Extract: Statistical Account
of Fife Parish of Largo - 1845
" ... Many years ago, coal was wrought in
large quantities, especially near the coast. At present, there are
three seams wrought, but none of them are of the first quality. To
the north of New Gilston a singular mass of rum coal is found,
under the mass of overlying trap on the south. It is an inflammable
bituminous shale, and is extensively used for lime-burning. It is
known to be 80 feet thick, and is wrought in an open quarry.
..."
--------------------------------------------
"Fifeshire Journal"
25 January, 1849 Reduction in the Price of Coals
ANDREW LAING, Tenant of CARURLIE COAL WORK, begs
to intimate a farther reduction in the Price of his Great Coal,
namely -
5s. 3d. per Ton, or 11d. per Load of 3½ cwt.
Carhurlie Coal Work,
22d January, 1849.
--------------------------------------------
Information on coals found at, or near,
the Carhurlie pits
(Based on a report from 1900)
In the Teasses and Carhurlie coalfield, the two coals
which came next above the Hurlet Limestone were worked
between Hall Teasses and Nether Pratis for a distance of
nearly three miles. In the old pits, the lower seam, two feet
thick, consisted half of parrot and half of cherry coal. The
upper seam had a thickness of 4 ft. 10 in. but included a
parting of black shale 1 ft. 2 in. thick. The mining of these
seams does not seem to have been disturbed by many large
faults, however, the crop of the upper or main seam was
interrupted by an igneous mass which lay to the north of
Nether Pratis and crossed the Hatton Burn below Houndshead
Bridge.
On the west side of the coalfield a good section, laid
open by the Hatton Burn, between Houndshead Bridge and
Thomsford Bridge, showed that the strata there were
exceptionally regular with a steady south-easterly dip. The
outcrop of one of the lower coals was seen just below
Houndshead Bridge, and the crops of several higher seams were
exposed in the same water-course further south than the seam
of limestone which crossed the burn at Carhurlie.
In the early part of the 19th century, a good deal of
coal-mining appears to have been in progress around
Carhurlie. Four coal seams were known.
Of these, the lowest was 2 ft. 8 in. thick, overlain by 3
ft. of shale with 1 ft. 3 in. of good coal on top. The second
seam was 1 ft. 3 in. thick and very soft; the third, 2 ft. 6
in. thick, 9 in. being splint and the rest very slaty parrot;
the fourth seam was 1 ft. 3 in. thick.
The coal was worked between the Hatton Burn and Balcormo
Mains, where traces of these pits could still be seen around
1900. It was also mined on the southern side of the stream,
as may be seen from the remains of old pits around Pilmuir
(see separate entry).
The section in the Hatton Burn showed that the strata, after
dipping steadily at angles of from 8o to
25o or 30o to the south-east, flattened
towards Thomsford Bridge and then began to dip towards the
west and north-west.
It was felt that if the same regularity continued on the
south-east, as on the north-west, of the little Thomsford
basin, the Carhurlie coals should re-appear between Hatton
and Lundin Mill. This indeed proved to be the case (see
Lundin Mill entry) but these coal seams were cut off to the
south by the huge fault which brought in the Upper
Coal-Measures between Blacketyside and Largo.
... and from a 1954 report ...
According to the records of several 19th century borings
put down in the area around Pilmuir, Hatton and north of
Lundin Links, there was a group of eight coals in a total
thickness of 30 to 35 fathoms of strata. Of these coals all
but the two highest were recorded at least once with a
thickness of 2 ft. or more, and the lowest of them, locally
called the Carhurlie Coal, was known to have been
worked.
Like the other coals in the group, the Carhurlie Coal varied
greatly in its development, but it usually occurred in two
leaves separated by a foot or two of sandy or shaly strata.
The recorded thicknesses of the two leaves were summarised as
follows: lower leaf, up to 23 in. (average 12 in.); upper
leaf, 7 to 48 in. (average 28 in.).
The topmost few inches of the upper leaf were described as
rum coal, a very inferior variety of coal.
The following sections illustrate the development of the
Carhurlie Coal in the Pilmuir-Lundin district.
BACK KNOCK BORE (W)
(550 yds. N.W. of Pilmuir)
| Description |
Thickness |
| Light grey shale |
- |
| Black Rum COAL |
6 in. |
| COAL |
2 ft. |
| Grey sandstone |
2 ft. 3 in. |
| COAL, good |
1 ft. 6 in. |
LUNDIN No. 15 BORE
(650 yds. N.N.W. of Pilmuir)
| Description |
Thickness |
| Grey sand with shale |
- |
| Black Rum COAL |
4½ in. |
| IRONSTONE band |
1½ in. |
| COAL |
2 ft. 8 in. |
| Sandstone, grey, with shale |
2 ft. 1 in. |
| COAL |
1 ft. 9 in. |
HATTON No. 1 BORE
(200 yds. S.S.E. of Hatton)
| Description |
Thickness |
| Fakes and blaes |
- |
| COAL |
2 ft. 7 in. |
| Fakes and blaes |
2 ft. 2 in. |
| COAL |
1 ft. 11 in. |
| Fakes and fireclay |
1 ft. 8½ in. |
| COAL |
10½ in. |
| Fakes and blaes |
- |
MILLACRES No. 1 BORE
(about 1 mile N. of Lundin Links)
| Description |
Thickness |
| Fakes and blaes |
- |
| COAL |
2 ft. 6¾ in. |
| Fakes |
10½ in. |
| COAL |
1 ft. 1½ in. |
| Fireclay |
- |
|